Abstract
In this study, it is shown that two-dimensional (2D) thermal resistance analysis is a rapid and simple method to predict the power generated from a waste heat recovery system with thermoelectric generators (TEGs). Performance prediction is an important part of system design, generally being simulated by numerical methods with high accuracy but long computational duration. Use of the presented analysis saves much time relative to such numerical methods. The simple 2D model of the waste heat recovery system comprises three parts: a recovery chamber, the TEGs, and a cooling system. A fin-structured duct serves as a heat recovery chamber, to which were attached the hot sides of two TEGs; the cold sides were attached to a cooling system. The TEG module and duct had the same width. In the 2D analysis, unknown temperatures are located at the centroid of each cell into which the system is divided. The relations among the unknown temperatures of the cells are based on the principle of energy conservation and the definition of thermal resistance. The temperatures of the waste hot gas at the inlet and of the ambient fluid are known. With these boundary conditions, the unknown temperatures in the system become solvable, and the power generated by the TEGs can be predicted. Meanwhile, a three-dimensional (3D) model of the system was simulated in FloTHERM 9.2. The 3D numerical solution matched the solution of the 2D analysis within 10%.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
