Abstract
The shell technique has been described for fabricating direct interim restorations by using conventional and computer-aided design and computer-aided manufacturing (CAD-CAM) methods. However, the positioning of the shell over the tooth preparations can be challenging. In the present manuscript, the clinical and laboratory steps for manufacturing a 2-piece magnet-retained shell for direct interim restoration fabrication are described. The 2-piece shell was produced by combining milling and additive manufacturing procedures. The described technique aims to simplify the correct positioning of the shell and facilitate direct interim restoration fabrication.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
