Two-layered quasi-3D finite element model of the oesophagus

Abstract

Analysis of oesophageal mechanoreceptor-dependent responses requires knowledge about the distribution of stresses and strains in the layers of the organ. A two-layered and a one-layered quasi-3D finite element model of the rat oesophagus were used for simulation. An exponential pseudo-strain energy density function was used as the constitutive equation in each model. Stress and strain distributions at the distension pressures 0.25 and 1.0 kPa were studied. The stress and strain distributions depended on the wall geometry. In the one-layered model, the stress ranged from −0.24 to 0.38 kPa at a pressure of 0.25 kPa and from −0.67 to 2.57 kPa at a pressure of 1.0 kPa. The stress in the two-layered model at the pressure of 0.25 and 1.0 kPa varied from −0.52 to 0.64 kPa and from −1.38 to 3.84 kPa. In the two-layered model, the stress was discontinuous at the interface between the muscle layer and the mucosa–submucosa layer. The maximum stress jump was 1.67 kPa at the pressure of 1.0 kPa. The present study provides a numerical simulation tool for characterising the mechanical behaviour of a multi-layered, complex geometry organ.