Two improved scanning path planning algorithms and a 3D printing control system with circular motion controller

Abstract

PurposeThis paper aims to improve the infilling efficiency and the quality of parts forming. It proposes two improved scanning path planning algorithm based on velocity orthogonal decomposition.Design/methodology/approachThe algorithms this paper proposes replace empty paths and corners with circular segments, driving each axis synchronously according to the SIN or COS velocity curve to make the extruder always moves at a constant speed at maximum during the infilling process. Also, to support the improved algorithms, a three-dimensional (3D) printing control system based on circular motion controller is also designed.FindingsThe simulation and experiment results show that the improved algorithms are effective, and the printing time is shortened more significantly, especially in the case of small or complex models. What’s more, the optimized algorithm is not only compact in shape but also not obvious in edge warping.Research limitations/implicationsThe algorithms in this paper are not applicable to traditional motion controllers.Practical implicationsThe algorithms in this paper improve the infilling efficiency and the quality of parts forming.Social implicationsThere are no social implications in this paper.Originality/valueThe specific optimization method of parallel-line scanning algorithm based on velocity orthogonal decomposition is replacing the empty paths with arc corners. And the specific optimization method of contour offsetting algorithm based on velocity orthogonal decomposition is to add connection paths between adjacent contours and turn all straight corners into arcs. What’s more, the 3D printing control system based on the circular motion controller can achieve multi-axis parallel motion to support these two improved path scanning algorithms.