Abstract
The most important aim of oral implantology is to improve the retention of complete mandibular dentures, which are often associated with problems in jaws with advanced ridge resorption and in the process improve patient’s satisfaction. In this article, the fabrication process for 2-implant overdenture is described and illustrated. The retentive elements for the implant abutment were housed directly into the fitting surface of the denture with the help of autopolymerizing resin through a simple chair side technique. It represents a case of a typical edentulous patient looking for low-cost improvement of denture retention.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Clinical Implant Dentistry with DVD
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.