Two-dimensional photoelastic simulation of a castable ceramic fixed partial denture

Abstract

Two-dimensional photoelastic models were used to determine the optimum design and loading conditions for a three-unit castable ceramic fixed partial denture. Findings relating to design and material variables can be summarized as follows. 1. Higher modulus cements impart more rigidity to the fixed partial denture design and result in lower stresses. 2. A short connector results in higher stress than a long connector; however, the length of the connector should not exceed one half the mesial-to-distal length of the pontic. 3. An intermediate thickness of cement results in the best stress distribution. 4. The male connector is best attached to the bulkier abutment. 5. Occlusal cement eccentricity is less desirable than cervical eccentricity. 6. The most undesirable loading site is directly above the connector.