Abstract
An attempt has been made to clad Mg alloy with Al by twin-roll casting. This was done by inserting an Al sheet between the roll and the Mg alloy melt during twin-roll casting. Microstructural investigation across the transverse section of the as-cast Al-clad Mg alloy sheet reveals a very good interfacial bonding between Al and the base Mg alloy. Annealing of the Al-clad Mg alloy sheet results in the formation of layers of various intermetallic phases along the Mg/Al interface. Subsequent rolling of the as-annealed sheet significantly improves the formability of the reaction zone, as evidenced by the cracking of the base Mg alloy before the cracking of the reaction zone.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
