Tuning the Composition, Crystal Structure and Morphology of Manganese(III/IV) Oxide for High-Power Storage Applications

Abstract

If inherently intermittent renewable energy technologies are to offer a practical alternative to conventional heat engines, it is critically important that efficient, cost-effective and sustainable energy storage solutions are developed to decouple supply and demand profiles. A promising strategy is to pair the competitive energy densities of batteries with the superior cycling lifetimes and power densities of supercapacitors,[1] employing an appropriate maximum power point tracking (MPPT) system to optimise energy exchange between these complementary devices.[2] Mixed-valence manganese(III/IV) oxides (MnOz, where z ranges between 1.5 and 2.0) have emerged as foremost candidates for the electroactive material in supercapacitor cathodes due to their low toxicity, minimal cost,[3] ready availability (manganese appears at an average concentration of ca. 1,000 ppm in the Earth’s crust[4]), wide electrochemical stability window (ca. 1.0 V in aqueous electrolytes[5]), and high maximum theoretical specific capacitance (ca. 1,370 F g-1, based on the reduction of Mn4+ ions by a single electron[6]). Charge storage in MnOz is predominantly mediated by the pseudocapacitive intercalation of cations from the surrounding electrolyte in each discharge phase, followed by the release of these guest ions during charging.Of the various crystallographic phases of MnOz, cryptomelane (α-MnOz) and birnessite (δ-MnOz) polymorphs are deemed two of the most promising candidates for storage applications because they possess characteristically wide channels for intercalation/de-intercalation:[8,9] α-MnOz consists of ca. 4.6 Å diameter one-dimensional tunnels enclosed between corner-sharing MnO6 octahedra, whereas δ-MnOz comprises two-dimensional layers of MnO6 octahedra separated by ca. 7.0 Å. Herein, a scalable, low-cost synthesis procedure is discussed that enables the production of highly pseudocapacitive birnessite and cryptomelane electrodes with tuneable material characteristics, including particle morphology, crystallographic structure, average Mn oxidation state, and the level of pre-intercalation by Na+ and K+ ions.[10] In addition to comparing the electrochemical properties of these NaxKyMnOz products in aqueous conditions, their application within an asymmetric supercapacitor is showcased: by optimising the relative masses of a NaxKyMnOz cathode and activated carbon anode in a 100 cm2 aqueous full-cell configuration, discharge capacitances in the range 10-30 F g-1 can be achieved over a voltage span of 1.8 V at current densities as high as 10 A g-1, with Coulombic efficiency exceeding 80% up to ca. 20 A g-1. With these competitive performance characteristics, the developed NaxKyMnOz materials are a promising option for high-power supercapacitor cathodes, helping to pave the way towards more efficient and sustainable energy storage.