Abstract
AbstractThis contribution demonstrates and discusses electrically tunable polymer planar Bragg gratings based on bulk cyclic olefin copolymers. A lithographic single‐writing‐step method and femtosecond laser reductive sintering of copper(II) oxide nanoparticles are subsequently employed in order to generate buried photonic structures and copper conducting paths on top of the polymer substrate. This way, the necessary number of process steps for fabricating a planar polymer‐based electro‐optical device is greatly reduced. The response of a fully electrified grating structure follows temperature changes, induced by the copper conducting path, with sensitivities up to −31 pm K−1. Dilatometric measurements show that the specimen's behavior is correlated to the situationally reduced thermal expansion of the bulk polymer substrate. In consequence, the tuning response of the photonic platform follows a second order polynomial, whereas a direct current of 30 mA, which correlates to a power consumption of 18.3 mW, leads to a local temperature increase and a residual Bragg wavelength shift of 19.6 K and −547 pm, respectively. Moreover, the outstanding flexibility of the proposed fabrication concept is underlined by demonstrating alternative conducting path geometries, whereas one of the additional designs is adapted to control the spectral width of the Bragg grating's reflection peak.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.