Abstract
Herein, interlaminar crack initiation and its growth in tufted carbon/epoxy composite under Mode-I loading are investigated for different thread materials and tuft densities. Two configurations of Double Cantilever Beam (DCB) test specimens are fabricated – one with 2 rows of tuft (hereafter referred to as lower tuft density) and another with 3 rows of tuft (will be referred to as higher tuft density). The crack front is arrested and delamination growth is delayed by tufting, which increases interlaminar fracture toughness(GIC). Higher enhancement in fracture toughness is observed for carbon thread tufted specimens followed by Kevlar and then glass thread tufted specimens. Fracture toughness of tufted specimens is about 4.5 to 10 times of untufted specimen depending on the thread material and tuft density. An increase in tuft density increases fracture toughness from 175% for Kevlar to 272% for glass threads. Fiber bridging from the parent laminate layer is observed in the untufted specimen, whereas in the tufted specimen, this phenomenon is insignificant except for bridging due to tufting thread. Fracture analysis shows that the failure is mainly due to the rupture of thread at the interface. Thread pull-out or slippage is absent exhibiting good adhesion with epoxy matrix.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have