Abstract

Abstract The objective of this paper is to showcase the successful and innovative troubleshooting data analysis techniques in one of the gas compression systems in upstream gas oil separation plants (GOSP-A). The gas compression system using gas compressors, dry gas seal systems and due point controls is used in almost all of upstream operation. These proven data analysis techniques were used to tackle major and chronic issues associated with gas compression system operation that lead to excessive flaring, mechanical seal failures, and off-specification products. Dry Gas mechanical seals are an important key element in gas compression and its lifetime represents a concern to the operation personnel. Most gas compression systems have a mechanical seal lifetime of 2 years which in some cases limit production, increase the potential of unnecessary flaring and increase OPEX significantly. In this paper, comprehensive data analysis of the potential root causes that aggravate undesired premature mechanical seal failures and off-specification gas products will be discussed along with solutions to minimize expected impact. For example, improper gas conditioning that feeds dry gas mechanical seals increase the risk of premature failures. Additionally, improper product specification in some applications have been found to promote seal failures and incur additional flaring which is both costly and environmentally undesirable. In addition, after extensive analysis improper operation practices during compressor startups, steady state operation and gas conditioning have been linked with premature compressor failures, product off spec and safety device failures. The field trial proved the effectiveness of the proposed innovative troubleshooting data analysis techniques in reinstating the gas compression unit in GOSP-A to its recommended design conditions, eliminated compressors and mechanical seal failures and avoided the off-specification products at the lowest operating cost. This innovative technique was based on deep and extensive process data analysis, evaluating operating and design data, reviewing international standards, benchmarking against other facilities, process simulation using Hysys, and finally the actual field trial.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.