Trisodium phosphate-loaded magnesium‑aluminum layered double hydroxides/oxidized-multiwalled carbon nanotubes self-assembled 2D-nanohybrid for designing a multifunctional smart epoxy nanocomposite

Abstract

In this study, a hybrid nanomaterial based on layered double hydroxides (LDH) and multi-walled carbon nanotubes (MWCN) was fabricated using a co-precipitation method. Trisodium phosphate (TP) was loaded into the designed nanocarrier to enhance the corrosion resistance of mild steel in 3.5 wt% NaCl media. Fourier transform infrared (FT-IR) spectroscopy, Raman, and X-ray diffraction (XRD) analyses were carried out to investigate the magnesium‑aluminum layered double hydroxides/oxidized-multiwalled carbon nanotubes (Mg-AL-LDH/O-MWCN) structure and morphology before and after loading of trisodium phosphate. Furthermore, the nanocarrier inhibition capability was evaluated through electrochemical impedance spectroscopy (EIS), polarization, and field emission-scanning electron microscopy (FE-SEM) techniques. Electrochemical impedance spectroscopy (EIS) was also employed to estimate the anticorrosion properties of the epoxy coating loaded with TP-LDH/O-MWCN. The EIS evaluation of the intact coating revealed the impedance at the lowest frequency (|Z|0.01 Hz) of about 109 Ω.cm2 after 42 days of immersion for the trisodium phosphate-layered double hydroxides/oxidized-multi-walled carbon nanotubes@epoxy (TP-LDH/O-MWCN@EP) sample and the lowest value of breakpoint frequency was obtained for this sample (fb = 0.063 Hz). These findings prove the trisodium phosphate-layered double hydroxides/oxidized-multi-walled carbon nanotubes (TP-LDH/O-MWCN) particles' effectiveness in the epoxy coating water/ion barrier function enhancement. EIS results indicated the enhancement of the charge transfer resistance (Rct) of the scratched coatings, from 65.97 kΩ.cm2 for the pure epoxy (EP) sample to 94.87 kΩ.cm2 for the trisodium phosphate-layered double hydroxides/oxidized-multi-walled carbon nanotubes@epoxy (TP-LDH/O-MWCN@EP) sample, revealing the self-repairing behavior of the designed coating. In addition, the adhesion properties of the samples coated with LDH/O-MWCN@EP and TP-LDH/O-MWCN@EP were studied by pull-off and cathodic disbonding tests, leading to a 33% reduction in adhesion loss and a 52.23% reduction in the diameter of cathodic delamination. The tensile test conducted on the samples indicated an increase in the ultimate tensile strength (σUTS), elongation break (Ɛb), and toughness values by 188%, 223%, and 800%, respectively, in comparison with the pure epoxy (EP) sample.