TRIP型ベイニティックフェライト鋼の表面残留応力に及ぼす微粒子ピーニングの影響

Abstract

To apply a transformation-induced plasticity (TRIP)-aided steel consisting of bainitic ferrite structure matrix and metastable retained austenite of 10 vol% (TBF steel) to some precision gears, the effects of fine particle peening on the Vickers hardness and residual stress in a surface layer of the TBF steel were investigated. The peened surface layer showed much higher Vickers hardness and compressive residual stress than those of a quenched and tempered SNCM420 steel. The increased Vickers hardness was mainly caused by an increase in the strain-induced transformed martensite fraction. The compressive residual stress was increased by the increases in size and gravity of shot material and arc-height. The higher compressive residual stress was principally associated with (1) plastic strain due to severe plastic deformation and (2) expansion strain due to the strain-induced transformation of metastable retained austenite. Contribution of the (2) was approximately 30% of total residual stress.