Abstract
In tissue engineering, there is a growing interest in the development of 3D printable bone tissue-inspired nanocomposites. However, most such nanocomposites have poor mechanical properties, owing to poor dispersion of the mineral phase (e.g. nano-hydroxyapatite, nHA) within the organic phase (e.g. methacrylated gelatin, GelMA) and low volume fractions of each phase. Triethyleneglycol dimethacrylate (TEGDMA) is commonly added to dental resin-based composites to improve the properties of the dental resin. Here, the effects of substituting a portion of the water phase in a GelMA-nHA composite with TEGDMA were evaluated. TEGDMA improved the dispersion of nHA within the highly-concentrated GelMA-based composite ink, as well as increased the ink's shear yield strength and reduced the critical energy for ink cure. As a result, the printability of the composite ink was greatly improved upon TEGDMA inclusion. Lastly, while the swelling of the cast composite in 37°C water increased slightly, the mechanical properties (tensile strength, toughness, and stiffness) of the cast composite increased by at least an order of magnitude upon TEGDMA addition, and all composites demonstrated MSC cytocompatibility after 24h. Overall, TEGDMA shows promise as an additive to tune properties of the GelMA-nHA system towards use in tissue engineering applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.