Tribological properties of Cr- and Ti-doped MoS2 composite coatings under different humidity atmosphere

Abstract

Abstract Solid-lubricant MoS 2 coatings have been successfully applied in high vacuum and aerospace environments. However, these coatings are very sensitive to water vapor and not suitable for applications in moist environments. In this work, Cr- and T-doped MoS 2 composite coatings were developed. The results demonstrated that these composite coatings are promising for applications in high humidity environments. MoS 2 –Cr and MoS 2 –Ti composite coatings with different Cr or Ti content were deposited on high speed steel substrate by unbalanced magnetron sputtering. The composition, microstructure, and mechanical properties of the as-deposited MoS 2 -metal composite coatings were analyzed by energy dispersive analysis of X-ray (EDX), X-ray diffraction (XRD), and nanoindentation experiments. The tribological properties of the coatings were evaluated against an alumina ball under different relative humidity atmosphere using a ball-on-disc tribometer. The MoS 2 –Cr and MoS 2 –Ti coatings showed a maximum hardness of 7.5 GPa and 8.4 GPa at a dopant content of 16.6 at.% Cr or 20.2 at.% Ti, respectively. The tribological test results showed that, with a small amount of Cr and/or Ti doping, the tribological properties of MoS 2 coatings under humid atmosphere could be significantly improved. The optimum doping level was found to be around 10 at.% for both MoS 2 –Cr coatings and MoS 2 –Ti coatings to show the best tribological properties, with both the lowest friction coefficient and wear rate. The excellent tribological properties of the MoS 2 –Cr and MoS 2 –Ti coatings with an appropriate metal doping level in moist atmosphere are found due to their ability to form stable transfer layer on the surface of the counterbody, which supplies lubrication for the contact surface.