Abstract
ABSTRACTThe tribological properties of thermosetting polyimide (TPI) mated with Si3N4, Al2O3, and GCR15 balls are investigated from room temperature to 300°C. TPI mated with ceramic balls shows a lower coefficient of friction (COF) and wear rate (WR) at room temperature due to the lack of a transfer film on TPI–ceramic balls, which is demonstrated by energy-dispersive spectroscopy (EDS) and different wear mechanisms. A conclusion is drawn that a transfer film cannot form on ceramic balls due to the low chemical activities of ceramic materials, especially under higher load conditions. Under high temperatures, COFs of TPI–ceramic balls present a diverse trend compared to TPI–GCR15. Moreover, transfer films on ceramic balls begin to form as the temperature increases, which is easily determined by EDS of the tribological marks on ceramic balls. The differences presented above can mainly be ascribed to the diversities of different properties of mated balls.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.