Abstract
The purpose of this study is to find out the tribological characteristics of the various lubricants in cold forging of helical gear, which is used in mobile auto-transmission. Five kinds of lubricant were used in this study, i.e. L1, L2, L3, L4 and L5. The pin-on-disk type of friction wear test system has been adopted here. The normal load of 20, 40, 60, 80 and 100N has been applied to the test specimen. The sliding velocities were 0.06, 0.10, 0.14, 0.18, 0.22, 0.26, 0.30 and 0.34m/s. Experimental results show that the friction coefficients of oils having higher kinematic viscosity such as L1, L2, L4 and L5 tend to increase gradually as the sliding velocity increases. The increasing rate of the friction coefficient is relatively high in lower sliding velocity range. However in case of L3 which has low kinematic viscosity the friction coefficient tends to decrease as the sliding velocity increases. The friction coefficients of Bondelube and Bondelite were 3 times higher than those of L1 and L5. The Stribeck curve indicates that L1, L2, L4 and L5 were in hydrodynamic lubrication condition and L3 was in boundary lubrication condition. SEM micrographs revealed that there were some scratch, adhesive wear, adhesion wear and scuffing on the worn surface.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
