Tribological characteristics of amorphous hydrogenated (a-C:H) and tetrahedral (ta-C) diamond-like carbon coating at different test temperatures in the presence of commercial lubricating oil

Abstract

Currently, the application of diamond-like carbon (DLC) coatings for automotive components is becoming a favorable strategy to cope with the new challenges faced by the automotive industry. DLC coatings can effectively lower the coefficient of friction (CoF) and wear rate of engine components, consequently improving the fuel efficiency and durability of these components. Commercially available fully formulated lubricating oils enhance the lubrication of ferrous materials. Therefore, the interaction between nonferrous coatings (e.g., DLC) and commercial lubricating oil must be investigated. A ball-on-plate tribotester was used to run the experiments using stainless steel plates coated with amorphous hydrogenated DLC (a-C:H) and tetrahedral DLC (ta-C) sliding against a 440C stainless steel ball. Wear track was investigated by scanning electron microscopy and atomic force microscopy. Energy dispersive spectroscopy and X-ray photoelectron spectroscopy were used to analyze the tribofilms inside the wear track. Raman analysis was performed to investigate the structural change of the coatings. At high temperatures, the CoF decreases but the wear rate increases in the a-C:H and ta-C DLC-coated plates. CoF and wear rate (coated layer and counter surface) are mostly influenced by coating graphitization. Tribochemical films, such as polyphosphate glass, are formed in ta-C and act as protective layers. Therefore, the wear rate of ta-C DLC is lower than that of a-C:H DLC.