Abstract
Tribological behaviour of aluminium alloy (Al-Si10Mg) reinforced with alumina (9%) and graphite (3%) fabricated by stir casting process was investigated. The wear and frictional properties of the hybrid metal matrix composites was studied by performing dry sliding wear test using a pin-on-disc wear tester. Experiments were conducted based on the plan of experiments generated through Taguchi’s technique. A L27 Orthogonal array was selected for analysis of the data. Investigation to find the influence of applied load, sliding speed and sliding distance on wear rate, as well as the coefficient of friction during wearing process was carried out using ANOVA and regression equations for each response were developed. Objective of the model was chosen as ‘smaller the better’ characteristics to analyse the dry sliding wear resistance. Results show that sliding distance has the highest influence followed by load and sliding speed. Finally, confirmation tests were carried out to verify the experimental results and Scanning Electron Microscopic studies were done on the wear surfaces.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Minerals and Materials Characterization and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
