Abstract
The use of Al-alloys for engine blocks production, instead of e.g., gray cast iron, results with weight savings and lower fuel consumption and therefore, reduces pollution. Possible solution for overcoming poor tribological properties of Al-alloys is the application of thermal spray coatings. In this paper, the tribological properties of two ferrous-based coatings were analyzed and compared with gray cast iron as a standard material for engine blocks. The process used for coating deposition on an Al-Si alloy substrate was atmospheric plasma spraying. In order to investigate the tribological behavior of these coatings under dominant adhesive and abrasive wear regime, two tests were applied with different test equipments and conditions. Both tribological tests showed that, for the investigated conditions, both coatings had improved wear resistance and lower coefficient of friction compared with gray cast iron.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
