Abstract
THE adsorption and condensation of water on the surface of insulators was responsible for the failure of much electrical equipment under service conditions in the tropics. From the literature of flotation1, it was known that the adsorption of a unimolecular film of an amphipathic (polar – non-polar) compound gives to solid surfaces a paraffin-like character, rendering them less readily wetted by water. Some typical flotation reagents were therefore applied to glass and steatite ceramic surfaces in an endeavour to improve their electrical insulation resistances under moist conditions. As might be anticipated from the work of Wark2, the quaternary ammonium compounds were effective. The accompanying table shows the results obtained with various substituent radicals for glass microscope slides and steatite terminal bushings. These were cleaned with chromic acid, immersed for about one second in an aqueous solution of the quaternary ammonium salt, and then washed thoroughly in distilled water.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
