Treatment of Chemical-compounds with Heated Vapor Subtraction System

Abstract

[Abstract] Heated Soil Vapor Extraction (HSVE), developed by Advanced Remedial Technology is a Soil remediation process that has gained significant attention during the past few years. HSVE along with Air sparging has been found to be an effective way of remediating soil of various pollutants including solvents, fuels and Para-nuclear aromatics. The combined system consists of a heater/boiler that pumps and circulates hot oil through heating wells, a blower that helps to suck the contaminants out through the extraction well, and air sparging wells that extend down to the saturated region in the soil. Both the heating wells and extraction wells are installed vertically in the saturated region in contaminated soil and is welded at the bottom and capped at the top. The heat source heats the soil and the heat is transported inside the soil by means of conduction and convection. This heating of soil results in vaporization of the gases, which are then absorbed by the extraction well. Soil vapor extraction cannot remove contaminants in the saturated zone of the soil that lies below the water table. In that case air sparging may be used. In air sparging system, air is pumped into the saturated zone to help flush the contaminants up into the unsaturated zone where the contaminants are removed by SVE well. In this analysis an a ttempt has been made to predict the behavior of different chemicals in the unsaturated and saturated regions of the soil. This analysis uses the species transport and discrete phase modeling to predict the behavior of different chemicals when it is heated and absorbed by the extraction well. Such an analysis will be helpful in predicting the parameters like the distance between the heating and extraction wells, the temperature to be maintained at the heating well and the time required for removing the contaminants from the soil.