Abstract

A small vacuum chamber aperture is a present trend in the design of future synchrotron light sources. This leads to a large resistive-wall impedance that can drive coupled-bunch instabilities. Another trend is the use of passively driven cavities at a harmonic of the main radio frequency to lengthen the electron bunches in order to increase the Touschek lifetime and reduce emittance blowup due to intrabeam scattering. In some cases, the harmonic cavities may be tuned to fulfill the flat potential condition. With this condition met, it has been predicted in simulation that the threshold current for coupled-bunch resistive-wall instabilities is much higher than with no bunch lengthening at all. In this paper, the features of a bunch in the flat potential that would contribute toward this stabilization are identified and discussed. The threshold currents for these instabilities are estimated for the MAX IV 3 GeV storage ring at different values of chromaticity using macroparticle simulations in the time domain and, within the limits of the existing theory, frequency domain calculations. By comparing the results from these two methods and analyzing the spectra of the dominant head-tail modes, the impact of each of the distinguishing features of a bunch in the flat potential can be explained and quantified in terms of the change in threshold current. It is found that, above a certain chromaticity, the threshold current is determined by the radial structure of the zeroth-order head-tail mode. This happens at a lower chromaticity if the bunch length is longer.

Highlights

  • MAX IV is a synchrotron light source currently under commissioning in Lund, Sweden [1]

  • A small vacuum chamber aperture is a present trend in the design of future synchrotron light sources

  • The threshold currents for these instabilities are estimated for the MAX IV 3 GeV storage ring at different values of chromaticity using macroparticle simulations in the time domain and, within the limits of the existing theory, frequency domain calculations

Read more

Summary

INTRODUCTION

MAX IV is a synchrotron light source currently under commissioning in Lund, Sweden [1]. With the aim of achieving low emittance, the storage ring lattice includes strongly focusing quadrupoles, which are grouped with other types of magnets in combined function magnet blocks For these quadrupoles to reach high enough gradients, their poles must be close to the beam. The MAX IV 3 GeV ring will employ passively driven cavities at the third harmonic of the main radio frequency (rf) to lengthen the electron bunches. Length Lc (m) Design beam current (mA) Radio frequency (MHz) rf voltage (MV) Passive cavity harmonic Horizontal emittance (nm rad) Average vertical beta β (m) Vertical betatron tune Harmonic number h Momentum compacion αc Natural bunch length στ (ps) Lengthened bunch στ (ps) Energy spread σδ Energy loss per turn (keV) Vertical chamber aperture 2a (mm) Chamber resistivity ρ (Ωm)

GeV ring
Coupled-bunch instabilities
Laclare’s eigenvalue method
SIMULATIONS
Modal analysis
OTHER CASES
Intermediate bunch length
Broadband resonator
Findings
CONCLUSION
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call