Transparent Polycrystalline Alumina Ceramic with Sub-Micrometre Microstructure by Means of Electrophoretic Deposition

Abstract

The optical quality attainable in coarse-grained polycrystalline alumina is severely limited by grain-boundary scattering, which is inherent to non-cubic materials. The optical properties of sub-micrometre polycrystalline alumina are of growing interest triggered by the fact that a decrease in the grain sizes of the final sintered material yields an improvement in the optical quality while the scattering mechanism changes as the grain size becomes comparable with the wavelength of light. To achieve transparent alumina ceramics with a fine-grained microstructure, however, porosity and other defects must be avoided. This necessitates the optimization of processing and sintering procedures. Electrophoretic deposition (EPD) is a colloidal process in which ceramic bodies are directly shaped from a stable suspension by application of an electric field. Electrophoretic deposition enables the formation of homogeneous, uniform green microstructures with high density, which can be sintered to transparency. It is a simple and precise technique to synthesize not only monoliths, but also composites with complex geometries [1]. Alumina green bodies were deposited from stabilized aqueous suspensions with and without doping. Green alumina compacts were evaluated based on their pore size distribution and density. Densification behaviour was characterized by dilatometric studies conducted at constant heating rate. Samples were sintered at different temperatures with subsequent post-densification by hot isostatic pressing. Transparency was evaluated by means of spectroscopic measurements. The measured in-line transmission of the samples at 645 nm was more than 50 % and that is 58 % of the value of sapphire. The influence of dopings on transparency was investigated. The mechanical properties of the samples were tested.