Abstract
Although η, the number of neutrons released per neutron absorbed in a 232Th-233U (thorium) fuel cycle, is greater than 2 in the thermal spectrum and therefore the possibility of breeding in a water-moderated reactor exists, it has been found difficult to achieve in practice. It is useful to relax the constraint for breeding and examine a thorium cycle for pressurized water reactors PWRs, denoted as PWR-Th, with the provision that the shortfall be made up by 233U bred in a PWR operating on a uranium fuel cycle, denoted as PWR-U, both of which utilize bimetallic thorium-zirconium alloy cladding as part of the fuel rod design. The number of complementary PWRs that could be sustainably operated on a thorium cycle was seen to critically depend on the moderator-to-fuel ratio (MF). Detailed cycle-by-cycle analysis shows that at the end of the first cycle, the sustainability ratio, namely, the ratio of sustainable PWR-Th reactors to PWR-U reactors, is 1.07 at an MF of 1.91, 1.4 at an MF of 1.43, and 4.45 at an MF of 0.954. The shortfall in 233U was found to decrease continually in subsequent cycles with the sustainability ratio increasing to 1.45, 2.01, and 28.3 at the respective MF values of 1.91, 1.43, and 0.954 by the 25th cycle. Although the sustainability ratio increases with lower MF, the achievable discharge exposure decreases necessitating larger material throughput in reprocessing. Detailed evaluations for fuel thermal, mechanical performance and nuclear reactivity feedback parameters require a further narrowing of potential design parameters based on holistic considerations arising from reprocessing. The PWR-Th reactors generate only trace amounts of transuranic (TRU) waste, and combined with a PWR-U design with bimetallic thorium cladding that generates only a fourth of the TRU waste compared to the standard all-UO2 fuel cycle, a significant reduction in TRU waste is possible.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.