Abstract

Non-modal linear stability analysis results are presented for hypersonic flow over an elliptic cone with an aspect ratio of two at zero angle of attack, completing earlier modal instability analysis of flow around the same geometry. The theoretical framework to perform transient growth analysis of compressible flows on a generalized two-dimensional frame of reference is developed for the first time and is then applied to solve the initial-value problem governing non-modal linear instability on planes perpendicular to the cone axis, taken at successive streamwise locations along the elliptic cone. Parameter ranges examined here are chosen so as to model flight of the Hypersonic International Flight Research Experimentation 5 (HIFiRE-5) test geometry at altitudes of 21 km and 33 km, corresponding to Mach numbers 7.45 and 8.05 and unit Reynolds numbers $Re' = 1.07\times 10^7$ and $1.89\times 10^6$ , respectively. Results obtained indicate that the significance of the non-modal growth for laminar–turbulent transition increases with increasing flight altitude (decreasing Reynolds number). At a given set of flow parameters, transient growth is stronger in the vicinity of the tip of the cone and in azimuthal locations away from both of the minor (centreline) and major (attachment line) axes of the cone. Linear optimal disturbances calculated at conditions of maximal transient growth are found to peak in the crossflow region of the elliptic cone. These structures are elongated along the streamwise spatial direction, while being periodic along the spanwise direction with periodicity lengths of the same order of magnitude as the well-known structures identified as crossflow vortices in both experiments and simulations.

Highlights

  • Non-modal linear stability theory, based on solution of the initial-value problem in which the linearized Navier–Stokes equations can be recast, has elucidated laminar–turbulent transition paths in a number of shear flows in which linear modal theory, based on solution of the eigenvalue problem, has failed to predict transition (Trefethen et al 1993; Schmid & Henningson 1994; Tumin & Reshotko 2001; Tempelmann, Hanifi & Henningson 2010)

  • The linear global instability for hypersonic transition (LiGHT) code is an in-house Fortran code written in generalized coordinates and a suite of subroutines for the massively parallel solution of multi-dimensional complex non-symmetric eigenvalue problem (EVP) and singular value decomposition (SVD) problems arising in linear fluid flow instability (Quintanilha et al 2017; Quintanilha, Theofilis & Hanifi 2019; Cerulus et al 2020; Quintanilha, Cerulus & Theofilis 2020; Theofilis 2020; Cerulus, Quintanilha & Theofilis 2021; Quintanilha 2021)

  • The HIFiRE-5 geometry is modelled by a blunt-nosed elliptic cone of 2 : 1 aspect ratio and 0.86 m in length

Read more

Summary

Introduction

Non-modal linear stability theory, based on solution of the initial-value problem in which the linearized Navier–Stokes equations can be recast, has elucidated laminar–turbulent transition paths in a number of shear flows in which linear modal theory, based on solution of the eigenvalue problem, has failed to predict transition (Trefethen et al 1993; Schmid & Henningson 1994; Tumin & Reshotko 2001; Tempelmann, Hanifi & Henningson 2010). Juliano & Schneider (2010) performed experiments in the Boeing/AFOSR Mach-6 Quiet Tunnel (BAM6QT) facility with an aspect ratio 2 elliptic cone, and showed that the dominant mechanisms leading to transition are streamwise-aligned structures, identified as crossflow vortices between the centreline and the attachment line region. Choudhari, Li & Paredes (2020) extended the analysis of the HIFiRE-5b flight experiment using local theory (Tufts, Gosse & Kimmel 2018b) to study the linear stability of the boundary layer flow near the centreline of the elliptic cone, and found an N-factor that peaks close to the value that correlates with Mack mode transition in the HIFiRE-1 circular cone experiment.

Non-modal linear stability theory
The initial-value problem
Quantitative description of transient energy growth
Definition of the energy norm
Computation of transient energy growth
Computation of linear optimal disturbances
Domains studied
Boundary conditions
The LiGHT code
Base flow configuration
Verification of the global stability analysis
Non-modal linear stability analysis of the centreline flow
Non-modal stability analysis of the attachment line
Summary and conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call