Abstract
Results of dynamic or transient tests and steady state calibration of carbon monoxide and sulfur dioxide continuous air quality monitors are reported. Standard gases and permeation tubes were used to establish low level concentrations bpth for the steady-state calibration and the dynamic testing. The steady-state calibration was in excellent agreement with results obtained from grab samples of the calibration gas stream taken with standard gas bubblers and analyzed by the West and Gaeke procedure. Such tests have been carried out by other investigators with similar results. The important contribution of this paper lies in the application of dynamic testing techniques developed by the senior author and co-workers to determine the transient and frequency response characteristics of these air quality monitors.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
