Transient Analysis on Excavator Bucket with Gray Cast Iron and Vanadium

Abstract

Abstract: The excavator machines are power machines used in the Agricultural, Mining and Construction industry. The main purpose of this excavator is for digging, ground leveling and material transport operations etc. The excavator bucket part is subjected to various load forces. So in this project, the work is carried on the bucket by interchanging the composite materials like gray cast iron and vanadium. Since the bucket experienced so many loads like impact during digging transient analysis is carried out, the standard specimen prepared through stir casting technique and conducted tests on the specimen like tensile, compression, hardness, and impact test to validate the data. The main objective of this project is to design an excavator bucket using CATIA V5 software of 3-D modeling software. Then simulation did through ANSYS 19.2 software by transient analysis technique to know the deformation and stresses etc. And the results of deformation and stress are compared between Gray Cast Iron without Vanadium and Grey Cast Iron with Vanadium for comparing justified result.