Abstract

In this study, transglutaminase (TG), glucono-δ-lactone (GDL), and citric acid (CA) were used to induce the formation of whey protein isolate (WPI)-milk fat emulsion gels to embed lutein, and the emulsion gels induced in different ways were used for the preparation of processed cheese. The protective effect of emulsion gels induced in different ways on lutein was investigated, and the stability of lutein in emulsion gels and processed cheese was analyzed. The results showed that the acidification rate of CA was higher than that of GDL, which was the key step in acid-induced gels, and that the difference in acidification rate led to differences in gel structure. Compared with the 2 acid inducers (GDL and CA), TG exhibited greater potential for forming gel structures with high strength. The TG-induced emulsion gels showed the best physical stability and the highest embedding efficiency for lutein. After heat treatment (85°C), the GDL-induced emulsion gels had higher retention rate of lutein and showed good thermal stability compared with the CA-induced emulsion gels. The processed cheese added with the TG-induced emulsion gel had higher hardness and springiness compared with the processed cheese added with the other 2 kinds of emulsion gels, whereas the processed cheese added with the CA-induced emulsion gel had a lower density of network structure, showing porosity and a larger aggregated structure, but the highest bioavailability of lutein. These results provide valuable information for the formation of cold-set emulsion gel and provide the possibility for the application of emulsion gel embedding active substances in processed cheese.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call