Transformation of an Ancient Crop: Preparing California ‘Manzanillo’ Table Olives for Mechanical Harvesting

Abstract

As one of the oldest continuously produced tree crops in the world, it is ironic that table olive (Olea europaea) production has benefitted from few technological innovations, including harvesting. Two harvesting technologies, trunk shaking and canopy contact, have been identified. In a 2013 trial, a prototype canopy contact harvester successfully harvested 92% of a 5.3-ton/acre mechanically pruned crop, vs. 81% for a 12.8-ton/acre hand-pruned control crop in a 19-year-old, 13 × 26-ft grove, spaced at 139 trees/acre and adapted for mechanical harvesting with 6 years of mechanical topping and hedging. About 85% of the hand-pruned olives were cannable vs. 86% of the mechanically pruned olives. Over the 6 years of mechanical pruning, the mechanically pruned trees averaged an annual 4.2 tons/acre vs. 5.3 tons/acre with hand-pruned trees. Again in 2013, this same canopy contact harvester achieved 81% final harvester efficiency with a 5.8-ton/acre crop in a 12-year-old, 12 × 18-ft, 202-tree/acre, mechanically pruned hedgerow grove vs. 80% efficiency for a 5.17-ton/acre crop with hand-pruned hedgerow trees. Similarly, no significant differences in the percentage of cannable olives, fruit size distribution, or value per ton was produced by the pruning treatments. In this trial in which both hand and mechanical pruning were used to produce a hedgerow, the hand-pruned trees averaged 3.7 tons/acre vs. 4.3 tons/acre for mechanically pruned trees. In a commercial trial in 2012, the trunk-shaking harvester achieved 77% average harvester efficiency in a 40-acre, 180-tree/acre grove, with a 4-ton/acre crop prepared with both hand and mechanical pruning. These ongoing trials indicate that adapting groves with mechanical pruning does not decrease average annual yields and can produce table olive groves that can be mechanically harvested at a cost and speed that is competitive with hand harvesting.