Abstract
A correction method for the measurement of complex reflection coefficients using vector network analyzers is presented. The method is based on the invariance property of the cross ratio of the bilinear transformation and is traceable to calculable air line impedance standards. The application of an accurate diameter measurement system (laser micrometer and air gauge system) allows the treatment of air lines as inhomogeneous transmission lines consisting of a cascade connection of a number of equally spaced line sections. Each line section is assumed to be homogeneous and characterized by the characteristic impedance and the propagation constant, which are traceable to the measured diameter values. The presented procedure is an extension and improvement of prior work using the same principle of correction, whereas the air lines were specified by nominal diameter and length values. The aim of this work is to enhance the accuracy of the correction or to reduce the requirements of the manufacturing tolerances of air lines. The derived theory is accompanied by a brief uncertainty consideration and by measurement results obtained by PC-7 air lines at frequencies up to 18 GHz and by numerical simulation results for a hypothetical air line.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Instrumentation and Measurement
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
