Abstract
Trace metals are ubiquitous in urban ambient air, with mass concentrations in the range of a few microg/m3 down to less than 100 pg/m3. To measure such low concentrations represents a challenge for chemical and physical analysis. In this study, ambient aerosol was collected in Zürich (Switzerland) in 1-h intervals and three size fractions (aerodynamic diameters 0.1-1 microm, 1-2.5 microm, and 2.5-10 microm), using a three-stage rotating drum impactor (RDI). The samples were analyzed by energy-dispersive Synchrotron radiation X-ray fluorescence spectrometry (SR-XRF) to obtain size-segregated hourly elemental aerosol mass concentrations for Cr, Mn, Fe, Cu, Zn, Br, and Pb, along with S, Cl, and Ca under the selected experimental conditions. The high sensitivity of SR-XRF allowed for detection limits of <50 pg/m3 for most of the above elements, with a net analysis time of only 15 s per sample. The data obtained with this technique illustrate that there is a considerable gain of relevant information when time resolution for measurements is increased from 1 day to 1 h. The individual size fractions of a specific element may show significantly different short-term patterns.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.