Abstract
To measure trabecular bone strain changes resulting from three increasing subchondral bone defects in the medial tibial plateau. Cadaveric biomechanical model. Contact radiographs were made from coronal sections of human cadaveric proximal tibia under no load and loaded to 400 newtons (N). Digital images made from contact radiographs of unloaded specimens were compared to corresponding digital images of loaded specimens using in-house software that detects trabecular deformation and measure trabecular bone strain. Ten specimens were loaded intact and with three increasing circular subchondral bone defects and centered under the subchondral plates in the medial tibial plateau that were 10%, 20%, and 30% of the coronal width of the medial plateau. Maximum shear strain and minimum principal strain were measured at approximately 2,600 discrete points in the trabecular bone in the medial tibial plateau. Trabecular strain increased most dramatically as defects increased from the medium (20%) to the large (30%) defect. The regions of greatest strain elevation were between the physeal scar and joint line near the medial cortex. Small (10%) and medium (20%) defects resulted in modest strain elevations. Subchondral defects cause size-dependent elevations in trabecular bone strain in the medial tibial plateau. A size threshold may exist, above which the trabecular bone is subjected to rapidly increasing deformation under load.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.