Abstract
Abstract Deep drawing is one of the most commonly used sheet metal forming processes, which can produce metal parts at a high rate. One of the major problems in deep drawing is springback, which is mainly elastic deformation occurring when the tool is removed. The focus of this work is the prediction of springback in deep drawing for DC04 steel using a micromechanical modeling scheme. A novel method is used for the characterization of material that leads to cyclic stress-strain curve. Simulations are performed with the Yoshida Uemori (YU) model for the prediction of springback for a U draw-bend geometry. The maximum deviation between the geometries of experiment and the springback simulation for hat geometry is 2.2 mm. It is shown that this micromechanical modeling scheme allows us to relate the influence of the microstructure to the springback prediction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.