Abstract
AbstractThis paper presents optimization studies on the formation of cadmium free buffer layers for high efficiency copper indium diselenide (CIGS) thin film solar cells using a vapor phase route. Indium sulfide layers have been deposited on CIGS substrates by Atomic Layer Deposition (ALD) at substrate temperatures between 140 and 260 °C using indium acetylacetonate and hydrogen sulfide precursors. The parametric study of the deposition temperature shows an optimal value at about 220°C, leading to an efficiency of 16.4 % which is a technological breakthrough. The analysis of the device shows that indium sulfide layers give an improvement of the blue response of the cells as compared a standard CdS processed cell, due to a high apparent band gap (2.7-2.8 eV), higher open circuit voltages (up to 665 mV) and fill factor (78 %). This denotes high interface quality of the system. Atomic diffusion processes of sodium and copper in the buffer layer are evidenced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.