Towards an agent-based model to simulate osseointegration in powder-bed 3D printed implant-like structures

Abstract

The orthopedic industry is still searching for an efficient way to replace bone loss due to surgical procedures such as arthroplasty and limb-sparing surgery. Additive manufacturing (AM) presents an opportunity to manufacture affordable patient-specific implants. Optimization of the implant–bone interface to maximize osseointegration (bone ingrowth) has not been appropriately addressed. Mechanobiological models, suited to predict mechanical adaptation of bone, cannot be used to predict osseointegration inside implants as the implant is not exposed to any mechanical loading until it is fully accepted by the host body. Biological models relying on partial differential equations based on continuum approximation are not well-suited to predict the discrete phenomenon of osseointegration. This study proposes an agent-based modeling (ABM) approach for representing the osseointegration process for orthopedic implants produced by powder-bed additive manufacturing processes. Agent-Based Modeling (ABM) is a cellular automata based discrete computing technique that uses rule-based mathematics derived from experimental studies to simulate evolutionary phenomena. In this paper, osseointegration inside a hexagonal closed packing of AM powder particles is modeled using ABM. Cellular agents such as pre-osteoblasts and osteoblasts are realistically modeled as cubic cells. The proposed model underpredicts osseointegration at early stages but predicts osseointegration at around 21 days with sufficient accuracy when compared to the in vitro test conducted by Xue et al. in 2007.