Abstract
Minimum Quantity of Lubricant (MQL) has been used in the grinding process to make the process eco-friendlier. On the other hand, it brings some technical problems to this process: the clogging phenomenon, i.e., chips adherence on the wheel cutting surface. Although this phenomenon yields widely known negative effects on productivity and workpiece quality, few studies exist about clogging in MQL grinding. Thus, this paper aims to explain the clogging formation and evaluate its effects on workpiece finishing and geometrical tolerances. External cylindrical plunge grinding tests in quenched and tempered AISI 4340 steel with CBN wheel, varying lubri-cooling conditions were carried out. Clogging affects the cutting ability of the grinding wheel and impacts on the chip formation. The addition of water in the MQL flow reduced the clogging occurrence in 40%, which corroborated to a reduction of 51% the surface roughness and 58% the roundness error.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.