Toward reducing no-clean flux spatter during reflow soldering: Investigating the effect of flux type, solder mask, and solder pad design

Abstract

This comprehensive study dealt with the reliability issue of no-clean flux spattering from the solder paste during the reflow soldering process. Several factors entering the process were investigated: the type of flux in the solder paste (ROL0/ROL1 according to the IPC J-STD-004B standard), the type of solder mask (liquid photo imageable/directly printed), and the type of solder pad design (copper-defined/solder mask-defined). A unique design of the test board was developed for a proper evaluation of flux spatter spots spattered from the solder paste. The testing board included real-sized soldering pads and a boron-silicate glass slide as a target area, ensuring the same evaluation process for all samples. The results showed a strong influence of flux chemistry on spattering. Changing the flux from ROL1 to ROL0 reduced the flux spot occurrence by 62 % on average. The type of solder pad design also slightly affected the flux spattering. No significant difference was found between the used solder masks; therefore, it is possible to use the novel, directly printed one without increasing the risk of flux spattering.