Toughening of polyvinylchloride by methyl methacrylate–butadiene–styrene core–shell rubber particles: Influence of rubber particle size

Abstract

AbstractAn analysis was made on the effects of rubber particle size on the mechanical properties and deformation mechanisms of transparent polyvinyl chloride (PVC) blends containing core–shell methyl methacrylate–butadiene–styrene (MBS) impact modifiers. The critical interparticle distance was found not to be the criterion for the brittle‐ductile transition in the blends. In tensile tests, the blends with larger (100–280 nm) rubber particles exhibited intense stress‐whitening, while one blend with small (83 nm) rubber particles showed only slight stress‐whitening. These differences were due to an increase in resistance to cavitation with decreasing rubber particle size. Transmission electron microscopy studies on blends with a bimodal distribution of particle sizes showed that in the whitened zone of Izod specimens the larger rubber particles cavitated and expanded on yielding, while the smaller particles remained intact. However, Izod test results showed that small MBS rubber particles can toughen the PVC matrix very effectively, especially at low temperatures and at low rubber concentrations. The deformation mechanisms responsible for these effects were discussed. POLYM. ENG. SCI., 2012. © 2012 Society of Plastics Engineers