Toughening of polyamide 11 via addition of crystallizable polyethylene derivatives

Abstract

AbstractBACKGROUND: Conventional rubber‐like toughening modifiers are soft and amorphous, and when used to toughen polyamide 11 (PA11) they commonly induce a decrease in the tensile strength and modulus. In this study, crystallizable polyethylene (PE) derivatives, i.e. linear low‐density polyethylene (LLDPE) and maleic anhydride‐grafted polyethylene (PE‐g‐MA), were adopted to toughen PA11.RESULTS: Compared to pure PA11, a highest improvement by a factor of eight in the impact toughness was achieved; also, the tensile strength and modulus could be maintained at a relatively high level. PE‐g‐MA acted as a compatibilizer for PA11 and LLDPE, bringing strong interfacial adherence, and especially a domain‐in‐domain morphology observed in PA11/PE‐g‐MA/LLDPE (70/10/20 by weight) blends. The observation that PA11 was toughened by the crystallizable PE derivatives is discussed in depth, based on the combined effect of surface crystallization of LLDPE on pre‐formed PA11 crystallites and interfacial compatiblization between PA11 and PE‐g‐MA.CONCLUSION: The crystallizable PE derivatives LLDPE and PE‐g‐MA were shown to be effective toughening modifiers for the proportions PA11/PE‐g‐MA/LLDPE 70/10/20 (by weight), which is considered to be an optimum composition: special domain‐in‐domain morphology was observed indicating a good dispersion of PE in the PA11 matrix and strong interfacial adherence between PE phase and PA11 phase. The reason why strength and modulus were maintained at a high level in the as‐prepared blends was attributed to the existence of rigid crystalline domains in PE. Copyright © 2009 Society of Chemical Industry