Total Knee Arthroplasty in a Patient with Ipsilateral Painless Hip Arthrodesis: Technical Surgical Tips and a Novel Method for Intraoperative Navigation-Assisted Planning.

Abstract

Total knee arthroplasty (TKA) in the setting of a previous ipsilateral hip fusion/arthrodesis is an uncommon and challenging procedure. There is little information available in the literature on the challenges and techniques available to perform TKA in these patients. For a traditional TKA procedure, the patient is placed in the supine position and various knee-positioning devices are used to allow for adequate knee and hip flexion, which is required for surgical exposure and tibia preparation. Ipsilateral hip arthrodesis presents two major challenges: (1) Hip flexion is crucial for adequate knee flexion while the patient is supine during the TKA procedure, and (2) the use of advanced technology, specifically computer navigation and robotic-assisted surgery techniques, is limited due to the inability to acquire the hip center of rotation during surgery, due to the lack of hip motion. Therefore, equipment and positioning must be adjusted by the surgeon to facilitate TKA in these patients. This article reports the case of a 72-year-old male patient with a long-standing, painless right hip arthrodesis, presenting with end-stage osteoarthritis of the right knee, leg-length discrepancy, and an 11.6° difference between the mechanical and anatomical axes of the femur. We describe the unique surgical planning as well as the surgical positioning options that allow for adequate knee flexion and proper surgical exposure. Furthermore, we describe a novel method of computer-assisted navigation for intra-operative planning and execution utilizing a reflected tibia as a template for the distal femoral cut.