Abstract
Non-inductive (throttle-free) DC/DC converters are used in low-power and highly integrated electronic systems. A circuit analysis of the basic topologies of non-inductive DC/DC charge-pumped converters which perform typical DC-voltage conversions, i.e., lowering, raising and inverting, was carried out. The galvanic isolation between the input and output circuits of the converter was achieved even in the integrated version due to forming a time delay of the switches (Dead Time, DT), commuting a “flying” capacitor, which is transferring the charge to the storage capacitor and the load. A circuit of the DT driver was developed and its parameters, at which the through-current flow in the switch is prevented and the conditions of galvanic isolation of the input and output circuits are satisfied, were studied. The simulation was built with a popular Electronics Workbench software, widely used in training of specialists in radio electronics at higher educational institutions. The results of the study of the basic power characteristics of DC/DC conversion, such as output current and voltage, voltage transfer coefficient, efficiency, output equivalent resistance, were presented. The efficiency of conversion was estimated by varying the capacities of the “flying” and storage capacitors, the resistance of the switches in the closed state, and the frequency of switching. It is proved that the charge pumping method is simple and effective at low load currents (mA units), when both the voltage transfer coefficient from input to output and efficiency are high, and are approaching to “one”. However, with the increase of the load current, the voltage transfer coefficient and efficiency decrease, the output voltage ripples increase.
Highlights
Financial Disclosure: No author has a financial or property interest in any material or method mentioned
Non-inductive DC/DC converters are used in low-power and highly integrated electronic systems
The galvanic isolation between the input and output circuits of the converter was achieved even in the integrated version due to forming a time delay of the switches (Dead Time, DT), commuting a “flying” capacitor, which is transferring the charge to the storage capacitor and the load
Summary
Топология безындуктивных DC/DC преобразователей с гальваническим разделением цепей. Резюме. Проведен схемотехнический анализ базовых топологий безындуктивных DC/DC преобразователей с накачкой заряда, выполняющих типовые преобразования напряжения постоянного тока – понижение, повышение и инвертирование. Разработана схема формирователя DT и исследованы его параметры, при которых обеспечивается предотвращение сквозных токов через ключи, и выполняются условия гальванической развязки входной и выходной цепей. Представлены результаты исследования основных энергетических характеристик DC/DC преобразования, таких как выходные ток и напряжение, коэффициент передачи напряжения, КПД, выходное эквивалентное сопротивление. Что метод накачки заряда прост и эффективен при небольших токах нагрузки (единицы мА), когда коэффициент передачи напряжения с входа на выход и КПД высоки и приближаются к единице. Однако при увеличении тока нагрузки снижается коэффициент передачи напряжения и КПД, растут пульсации выходного напряжения. Ключевые слова: радиоэлектроника, DC/DC, преобразователь, накачка заряда, зарядовый насос, безындуктивный, моделирование, «летающий» конденсатор, конденсатор фильтра, пульсации, Х-точка. Топология безындуктивных DC/DC преобразователей с гальваническим разделением цепей.
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
