Topological and Mechanical Properties of Different Lattice Structures Based on Additive Manufacturing.

Abstract

The appearance and development of additive manufacturing technology promotes the production and manufacture of parts with more complex designs and smaller sizes and realizes the complex topology that cannot be made by equal-material manufacturing and submanufacturing. Nowadays, the application of tri-periodic minimal surface (TPMS) in topology optimization design has become a new choice, and, because of its excellent structure and properties, has gradually become mainstream. In this paper, the mechanical properties of four different topologies prepared by selective laser melting (SLM) using 316L stainless steel powder were investigated, including two TPMS sheet structures (Primitive surface, Gyroid surface) and two common lattice structures (Bcc lattice, truss lattice). The mechanical properties (Young’s modulus, yield stress, plateau stress, and toughness) were compared by numerical simulation and compression experiment. It can be concluded from the results that the mechanical properties and deformation mechanism of the specimen are mainly related to the type of lattice, though have little relationship with unit thickness at the same relative density. The Gyroid curved structure showed the best mechanical properties and energy absorption capacity, followed by the truss lattice structure. By comparison, the mechanical properties of the traditional Bcc lattice structure and the Primitive surface structure are poor, and the deformation mechanism of these two structures is uncertain and difficult to control.