Topography Response to Horizontal Slab Tearing and Oblique Continental Collision: Insights From 3D Thermomechanical Modeling

Abstract

AbstractThe horizontal propagation of slab detachment (slab tearing) is known to control lateral migration of the mountain uplift along the collisional belt. However, along‐strike differential collision due to an oblique passive margin geometry can make the topography response more complex. In this study, we employ 3D thermomechanical modeling to distinguish between the lateral migration of the mountain topography driven by slab tearing and oblique continental collision itself. In our models, slab breakoff is triggered by the transition from oceanic to continental subduction, occurring earlier on one side of the passive margin than on the other due to the initial oblique configuration. However, once slab breakoff has begun, it spreads horizontally in the form of tearing at high velocity (∼38–118 cm yr−1), and associated topographic uplift also propagates with the same velocity. In contrast, the along‐strike migration of subsequent continental collision and related topographic uplift propagation is typically much slower (∼2–34 cm yr−1). Similarly, the vertical magnitude of surface uplift caused by slab tearing is higher (up to 10 mm yr−1) than the following collision phase (<4 mm yr−1). The parametric analysis reveals that slab tearing velocity and the associated horizontal propagation of mountain uplift depends on obliquity angle and slab age, whereas the migration of collision‐induced topographic growth is controlled by the convergence velocity and obliquity angle. Finally, we show that presence of microcontinental block detached from the passive margin leads to spatial and temporal transition from horizontal to vertical slab tearing and more intense syn‐collisional mountain building.