Abstract
Topographies are one of the challenges for the development of the metal additive manufacturing promising technique. The article investigates multi scale topographies (from form to roughness) of as built surfaces generated by selective laser melting (SLM). Different building inclinations of samples were observed both for upskin and downskin surfaces with a wide range of measuring techniques. The two main aims are: (i) to make a critical review of measuring techniques at different scales, (ii) to enlighten the different surface generation phenomena (and the corresponding scale) occurring during additive manufacturing. The effect of heat treatment on each scale of the topography is also discussed. It is found that the focus variation technique is well suited for AM surfaces. Concerning the observation of the inclined surfaces, some parameters are emphasized as good indicators of typical signatures of AM surfaces: isotropy for the weld track component, the skewness and Rsm for the staircase effect, fractal dimension for the presence of partly melted particles. The different parameters studied helps to model and understand the different surface generation phenomena aforementioned.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
