Tooth structure loss apical to preparations for fixed partial dentures when using self-limiting burs

Abstract

Statement of problem. Burs with guide pins may be used to limit the depth of tooth preparation for fixed partial dentures. The effects of guide pins on tooth structure apical to the finish line after tooth preparation for fixed partial dentures has not been recorded. Purpose. This in vitro study recorded loss of tooth structure within 1.0 mm apical to the finish line of teeth prepared with straight cylinder and tapered cylinder self-limiting burs and one conventional bur. Material and methods. Forty-five extracted human teeth were randomly divided into three groups. The facial surface of each tooth was prepared with two types of diamond burs with guide pins and a conventional diamond for the control. The surface was profiled before and after tooth preparation. Profiled surfaces were analyzed and the groups were compared using analysis of variance and the Tukey-Kramer HSD test (α = 0.05). Results. No significant difference was recorded between the control group and the group prepared with a round-ended tapered cylinder self-limiting pin. However, there was a statistically significant difference between the control and cylindrical pin groups, and between the two groups prepared with self-limiting diamonds. Conclusion. This study revealed abrasion apical to the finish line of the preparation in all groups. The cylindrical guide pin group exhibited the greatest loss of tooth surface. (J Prosthet Dent 1998;79:491-4.)