Tooling materials compatible with carbon fibre composites in a microwave environment

Abstract

Although metals are the most commonly used tooling materials to cure composites, they do not provide optimal results in a microwave environment. Following a selection process based on the properties of the materials, an alternative tooling material in carbon fibre reinforced plastic (CFRP) was successfully utilised to cure CFRP panels in laboratory and industrial microwaves. The conductive carbon fibres in the tool facilitated the fast heat transfer across the part. Other tooling materials including a glass fibre cyanate ester prepreg and tooling board were trialled, although the latter exhibited damage during cure. These advantages demonstrate that the CFRP tool is a compatible material that can be used when microwave curing composites.