Abstract
In machining of reinforced fibre composite parts, abrasive fibres and material heterogeneity produce poor surface finish, delamination and tool wear. In this research, basalt fibre reinforced plastic is machined with edge trimming in order to study tool wear, using a tool holder of diameter 25 mm, with two exchangeable uncoated carbide cutting inserts. Cutting conditions (cutting speed, feed per tooth and depth) and material characteristics (fibre volume fraction and fibre orientation) are evaluated to know their influence in the flank wear (Vb) of the tool. An analysis of variance (ANOVA) was performed to study flank wear and material removal rate, and a generalized linear model (GLM) was developed. More influence variables in the flank wear are the machining conditions, being the tool life suitable for this machining and material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
