Abstract
In this study the machinability of ductile iron having ferritic structure was examined in interrupted cutting conditions. For this purpose, cylindrical samples with 1, 2, and 4 axial slots were prepared. Uncoated cemented carbide cutting tool was used in this work. Two different cutting speeds, feed rate and depth of cut were chosen as cutting parameters. According to results, the number of slots seriously affects the tool wear. Increasing the number of slots results in a decrease in the dimension of chip. Another result observed during the tool wear experiments was that increasing the number of slots results in increase of flank wear. However, the cutting tool wears out rapidly at higher feed rate or depth of cut when one or two slotted workpiece are used. Scanning Electron Microscope (SEM) and Energy Dispersive X-ray microanalysis (EDX) of the worn tools showed that abrasive, adhesion and oxidation wear mechanisms are predominant in the machining of continuous and interrupted cutting of ductile iron.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.