Tool Wear and Machined Surface Roughness during Wood Flour/Polyethylene Composite Peripheral Up-milling using Cemented Tungsten Carbide Tools

Abstract

The effect of sharpness angle on tool wear and the effect of tool wear on machined surface roughness were investigated in wood flour/polyethylene composite (WFPEC) peripheral up-milling using cemented tungsten carbide (TC) tools. It was shown that nose width and edge recession increased with increasing feeding length. During the milling process, the wear of the nose width was smallest for the tool with a sharpness angle of 45°, followed by tools with sharpness angles of 55° and 65°. The wear of edge recession was highest for the tool with a sharpness angle of 45°, followed by tools with sharpness angles of 55° and 65°. The nose width increased with increasing sharpness angle, the edge recession decreased with increasing sharpness angle, and the machined surface roughness increased with increasing sharpness angle after a feeding length of 40 m. The nose width had a positive effect on the machined surface roughness, and the machined surface roughness increased with increasing nose width. The edge recession had little effect on the machined surface roughness. The clearance face roughness of the worn tool increased with increasing sharpness angle. The analysis of the SEM micrographs and EDS of the clearance face of the worn tool showed that the wear mechanisms of the cemented tungsten carbide tool were oxidation and abrasion in the range tested during cutting. Thus, a slight wear of the edge recession is gained in exchange for a lower machined surface roughness by decreasing the sharpness angle.